
TEKBOX TBL05100-1C 5µH LISN
- 10 kHz – 400 MHz
- 100 A
- 1000 V DC
- < 5 mΩ
The TBL05100-1C is a 5µH line impedance stabilisation network (LISN) built for conducted emissions testing on high-current AC and DC supplies. It presents a defined impedance to the equipment under test (EUT), keeps noise from the power source out of the measurement and passes the EUT’s RF noise to a spectrum analyzer or EMI receiver through an N-female connector.
DC resistance stays below 5 mΩ on both paths, so voltage drop and self-heating stay low under heavy load. The LISN handles up to 500 V AC at 50/60 Hz, 250 V AC at 400 Hz and 1000 V DC, with internal components rated to 1500 V DC. As the TEKBOX Top 1 Distributor, ELSYS recommends it for automotive, aerospace, defence and EV power electronics where currents reach 100 A.
Key specifications
- Supported standards
- CISPR 16-1-2, CISPR 25, MIL-STD-461G, DO-160, ISO 11452-4, ISO 7637-2
- Characterised frequency range
- 10 kHz – 400 MHz
- Inductance
- 5 µH
- DC resistance
- < 5 mΩ Source+ to EUT+; < 5 mΩ Source- to EUT-
- Maximum current
- 100 A (heat-up characteristics in datasheet chapter 8)
- Operating voltage
- 0–500 V AC @ 50/60 Hz; 250 V AC @ 400 Hz; 1000 V DC
- Absolute maximum (internal components)
- 1500 V DC
- RF connector
- N-female
- EUT and SOURCE connectors
- Binding post M8, 4 mm centre hole, 100 A, 1 kV (Schützinger POL 102 L / RT)
- Earth
- 8 mm
Where it fits
CISPR 25 component tests on EV traction inverters, DC-DC converters and battery management systems; MIL-STD-461G and DO-160 conducted emissions on aircraft and defence electronics; and the line network for ISO 7637-2 transient tests. Pair it with a RIGOL spectrum analyzer for a complete pre-compliance setup from the TEKBOX Top 1 Distributor.
Get a TBL05100-1C quote
